### Biodiesel Plant 15 MGY ### Biodiesel plant with nameplate rating at 15 MGY (million gallons per year). Was designed to run soybean oil and was in operation on crude degummed oil. Complete plant is available - must be relocated. Does not include electrical. The entire plant is inside in a protected building except for the methanol distillation column. Allen Bradley plc controls. Still installed. Plant never met nameplate capacity but average rate was between 6 to 8.7 MGY. In operation from 2020 to late 2021. Includes all in-process tanks, The 18 outside storage tanks are available on Asset 2365 and Asset 2366. We have details and drawings in our Virtual Data Room (VDR) - available upon invitation. - (3) biodiesel reactors - (3) horizontal settling tanks - Glycerin coalescer distillation column - Biodiesel coalescer distillation - MRU methanol recovery unit distillation column & system - Cold soak filtration system - Vertical pressure leaf filter and (2) plate and frame filters including slurry and earth handing systems - (2) Hydrasep oil water separators - Air compressors, pumps, heat exchangers - Allen Bradley controls, HMI

### Biodiesel Plant - 3 MGY (million gallons per year) ### Manufactured by Greenline, this plant ran cottonseed oil in a continuous flow, water free, transesterification reaction and separation modules. - On skids and includes in-process tanks. - Fully automatic with plc control; all controls are still there and intact except for the HMI. - No tank farm - No air compressor - This plant was just inspected by the manufacturer in Dec 2021 and all pieces are still there except for some water piping. - The manufacturer notes that this plant is in good condition and very little CapEx will be needed to start the equipment back up. Customer will have to make its own determination. - Plant must move. - Approx space is occupies now is 75 ft x 100 ft Started in 2008 - idled in 2010. We can offer two further options at an additional price: 1. Greenline refurbish all equipment and make ready for start-up. 2. Greenline install and start-up equipment at new location. See information in Links; more data in our Virtual Data Room (VDR).

Biodiesel Plant nameplate capacity 5 MGY (million gallons per year). Design is super critical reactor type, developed by Jatro Renewables. This design technology allows this plat to handle very dirty high ffa feedstock while operating cheaper than a conventional catalyst biodiesel plant. No toxic catalyst. Output biodiesel is much clearer than conventional biodiesel. See our marketing deck for lengthier explanations. No license fees. All assets are for sale as an entity - must be relocated. All structure included - building is not included. Includes lab equipment. See Marketing Deck general arrangement in Link. Operated from Nov 2015 to 2019 - now idle.

Biomass drying and ethanol solvent extractor system, last used for producing CBD Extract by drying hemp at 3,000 #/day infeed and approximately 1,000 #/day dry mass outlet. Was running hemp with infeed moisture of 50-80% and outlet moisture of 7% to 11% moisture. CBD extraction efficiency is very good. Unit was purchased new in 2019 - only has 1,289 hours operation. Main components include Gryphon gas fired dryer, ribbon blender, Watermark filter press system, Nutsche filter, BizzyBee distillation system, tanks. See Links for equipment list and process flow chart.For all components enter the key word pk6020 in search box..

### Hydrogen Generating Plant (partial) ### - Design capacity is 90,000 scfh at 200 psig with a purity of 99.99% pure hydrogen - was running on 10 of its 20 tubes for 45,000 scfh capacity. Burner has been changed out to run the 45,000 scfh capacity. - Reformer can be fired on natural gas or propane - same burner. - Waste heat boiler generating 3,000 to 5,000 #/hr export steam at 250 psig. - PSA plant (4 psa vessels replaced in 1998) with Jamesbury valves kept up to date, Quench pot design. - Plant is missing small natural gas compressor, heat exchangers, and pumps. - Has new tubes, new reformer, and new shift converter catalyst. - Five (5) spare tubes available. Engineered by Hydro-Chem built in 1980. . Plant was shut down in mid 2012, and proper shutdown procedures were followed. Reformer tubes are 6.625" OD, 5.25" ID, 30.825" long and made of alloy HP50 (also known as 25/35)

CO2 Scrubber System. CO2 scrubber size: 60" ID x 31'-11" s/s tall, Vent gas scrubber size 48" OD x 31'-11" s/s tall. stack. Material ss304. Includes structural towers for both columns, Goulds 3196 size 1.5x3-6 PC-3201 centrifugal pump, Kice 15HP blower BL-3202, knock out pots, and all instrumentation and valves associated with this system. For a list of components, entrer pk3201 in search on web site.

### Distillation System - for Corn Oil/Ethanol/Water Separation ### Skid mounted distillation system designed to remove ethanol and water from corn oil. Design capacity 10 gpm with infeed composition 95% oil and max 5% water/ethanol. Results: Corn oil output with 1000 ppm water max. - NEW - never used. Built 2019 - never commissioned, in protected warehouse - Stainless steel 304L - Includes SRS SRDX-600 flash distiller packed column 3 ft dia x 15 ft tall. Serial number 022619 - Two 150 gallon tanks - Vacuum pump - Two centrifugal pumps - Four plate heat exchangers - Piping and instrumentation. - All components are wired to the control panel on skid, but no plc - Spec'd for 19 gpm of ethanol/water flashed to azeotrope See Links for Equipment List and more details. P&ID available in Virtual Data Room (VDR) - ask for an invitation.

### Distillation System Enhancement - for ffa/Ethanol/Water Separation ### Skid mounted distillation system designed to remove ethanol from water. This skid was designed to be added to back of skid VR2 to further reduce the water content of the ethanol to 500 ppm-1000 ppm range. However, can also be a stand alone skid for reducing water/ethanol in other oil processes. - NEW - never used. Built 2019 - never commissioned, in protected warehouse - Stainless steel 304L - Includes SRS flash distiller column 10 inches dia 12 ft tall, serial number 00619 - One stainless tanks 2 ft dia - Two centrifugal pumps - Two plate heat exchangers - Piping and instrumentation. - All components are wired to the control panel on skid, but no plc - Capacity of VR3 is 3 gpm and is designed to remove <30% ethanol/water from oil down to 1000 ppm. See Links for Equipment List and more details. P&ID available in Virtual Data Room (VDR) - ask for an invitation.

### Ring Dryer, GEA Barr-Rosin ### Used for drying wet cake DDGS but can be used to dry almost anything – such as hemp or other grains. Dries material from 65% moisture to 11% moisture, evap rate 66,463 #/hr. This dryer was designed to handle 112,861 wet infeed at 65% moisture and 440,000 #/hr dry recycle material. This design lends itself well for varying flows and moistures, and precludes clogging or clumping. Comes with Lo-Nox main burner natural gas fired 83 MMBTU, a 1200HP main fan, 2 combustion/exhaust fans 150HP, Fluid Bed Cooler and Baghouse, (2) paddle mixers, (9) drag and screw conveyors, (4) rotary valves, (4) cyclones, disintegrator. Designed for 67,109 #/hr wet grain + 45,752 #/hr syrup IN = 46,398 #/hr OUT Evap rate 66,463 #/hr Fan: 189,339 scfm 1300HP. Burner heat 83.1 MMBTU. See data sheet, P&ID, and GA in Links. Still installed. For list of components and their photos & description enter dr5201 in search box on web site

## Fractionation Systems Pressure 30 bar - for Edible Oil ## - TWO complete systems including all tanks, pumps, heat exchangers, fitters, and controls. Includes all piping and everything in this room. ### 78 MTPD System ### Fractionation system - supplied by DeSmet, rated at 30 bar (450 psig). System built 1997. Includes (18) vertical crystallizers and Industrieterren membrane filter (made in Belgium) with 69 plates polypropylene. Capacity 78 MTPD based on first fractionation Palm Oil – OR - 18 MTPD OUTPUT based on 2nd Fractionation = 10.5 million pounds product + 3.5 million pounds by-product. Capacity will vary depending on type of operation and oil. - Membrane filter for fractionation, made by Industrieterrein Wijngaardveld AALST, Belgium. Serial 150 10. Type OGFP1500, rated at 30 bar. Has 69 plates, 1500mm x 1500mm. Filter cake volume = 2,875 liters (759.5 gallons). Filter area 255 sq m, with 25mm cake per cavity. Automatic with plc operator interface, on-board hydraulic system with dual acting cylinder. J4744 ### 40 MTPD System ### Fractionation system - supplied by DeSmet. System built 2000. Includes (6) vertical ss crystallizers and Filox membrane filter (made in Germany) with 36 plates polypropylene. Capacity 40 MTPD based on 1st fractionation Palm Oil – OR - 5 MTPD OUTPUT based on 2nd Fractionation = 2.5 million pounds product + 1.5 million pounds by-product. Capacity will vary depending on type of operation and oil. Stainless steel trough and auger system. Includes all tanks, pumps, electrical, and control systems. - Filox membrane filter for fractionation, rated at 30 bar (450 psig). Made by Filox - Filtertechnik Gmbh, Germany. Type MKF150-36-250H, serial 2117. Has 36 polypropylene plates, 1500mm section - cake volume 1500 liters, cake thickness 25mm, 40.5 sq m filter surface area. Automatic with plc operator interface, on-board hydraulic system with dual acting cylinder. Hydraulic unit 15HP. Size 6535mm long x 2820mm wide x 2610mm tall, weight empty 34,785 kg. J4747

Slurry tank system consisting of skid with vertical stainless steel tank, (2) Grundfos pumps. SS skid size is 98" x 68" x 84" tall. No agitation - Tank size is 5 ft dia x 6 ft tall for capacity of 850 gallons. Flat bottom, dish top with hinged manway lid. (atmospheric). Grundfos pumps are CRN15-08 A-FGJ-G-E-HOQE. Model A96127009-P11101551 designed for 90 gpm at 528 ft hd. Turning at 3444 rpm. Motor is 15 HP 3500 rpm 460/3/60. Supplies pressing water to Outotec Larox PF1.6 filter system. Part of Outotec Laroc Pressing System